Vintage Mustang Forums banner

Edelbrock intake with a shaker scoop?

Jump to Latest Follow

1 - 2 of 2 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter • #1 •
Hello, I was just hoping someone out there could help me out. I have a 390 with shaker in my 69 mach 1 and I was wondering if an Edelbrock RPM intake would fit without causing clearance problems with the hood. I have, already purchased a Performer intake that I know will fit but I've heard the RPM would be better for my engine. Any advice would be helpful.
When complete the engine will have headers, cam, and cobra jet heads.
Thanks

#12
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter • #2 •
It should fit fine...perhaps a little taller but w/o hood interference.
 
1 - 2 of 2 Posts
Recommended Reading
Read More

  1. Got my T5!

    Vintage Mustang Forum
    Well after lots of searching, want adds, bartering, "horse trading" I finally have a T5 to put in my car. I'm into it for $150 CAD ($110 USD) From all the research I did this will work fine for my "stockish" Sunday driver car. 1968 mustang 289, 3 speed. I will use my existing clutch and...

  2. 1965 mustang 289 fuel

    Vintage Mustang Forum
    289 When the engine gets warm, the next gasoline will not be in the filter and the engine will not start. Is the pump weak? I don't know how to solve it, whether or not the vent is bad. please tell me.

  3. What is this hole for in driver's floor pan?

    Vintage Mustang Forum
    I can't figure out what this hole is for in my driver's side floor pan below the accelerator pedal and just back of the seam from where the firewall piece meets the front floor pan. It's hard to tell from the picture now that I have POR-15 there but it's right where there is a little U-shaped...

  5. Roadtrip!

    Vintage Mustang Forum
    Hi Everyone, I've been reading a lot more than posting for the last few years, but that might change a bit considering my current undertaking. I'm roadtripping across the USA in my '69 Cougar. For those who don't know, the Cougar is basically a Mustang with different sheetmetal and a 3" longer...

  6. Looking for a fan controller that won’t keep running after I turn my car off

    Vintage Mustang Forum
    A gentleman never tells but I’m just looking at electric fan controllers for my car. I have a deralle adjustable one right now and the concern I have with it is that it stays on and attempt to cool my car until it gets to the correct temperature and it’s killing my battery. So im looking for...
Read More
About this Discussion
1 Reply
0 Participants
Last post:
Guest
Vintage Mustang Forums
A forum community dedicated to vintage Ford Mustang owners and enthusiasts. Come join the discussion about restoration, modifications, NOS parts, troubleshooting, VIN codes, and more!
Full Forum Listing
Explore Our Forums
Vintage Mustang Forum General Discussion (Non-Vintage Mustang) Mod and Custom Forum Classic Mustang Wanted Ads Concours Forum
Popular Communities
Community avatar for Home Entertainment
Home Entertainment
1,280,000+ members
Join
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Community avatar for Working From Home Forum - New!
Working From Home Forum - New!
25+ members
Join
Top