Vintage Mustang Forums banner

Edlebrock Performer RPM set up

820 Views 4 Replies 3 Participants Last post by  Guest
Is anyone using the Edlebrock RPM (heads and/or intake and cam) setup on your vintage stang? If so what kinds of improvements did you get and how do you like the set up?

1966 GT 350 Clone
289 (rebuilt with JE, Eagle, Arp)
Edleborck RPM Heads
Comp Cams hyd roller, Crane 1.6 rockers,
Holley 650 DP, Hookers 1 5/8, T-10, 3:55 Gears, Custom Dual exhaust with X Pipe
1 - 1 of 5 Posts
I used the edelbrock total power package, but modified it by going with the performer cam, performer rpm intake and the smaller valve version of the heads, the under 2.02 intake size. Also had the Edelbrock carb. Ran this for about 3 months, then tore the car down. The improvement was noticeable, but not a kick in the seat of the pants. I felt the cam and carb were holding back performance. So, I have now upgraded to a Holley carb and performer rpm cam. Car's not running yet so I cannot report on that improvement.

sure it's fun, but it's only a car.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.