Vintage Mustang Forums banner

Engine Back Plate

559 Views 3 Replies 4 Participants Last post by  SHELBY
What finish should the plate between the engine and the automatic transmission have on a 1968 302 ci ?

[color:red] 1968 J-code Convertible Mustang </font color=red>
[color:blue] 1991 Chevrolet Astro Starcraft </font color=blue>
[color:green] 1995 Saab 9000 CSE Turbo </font color=green>
1 - 4 of 4 Posts

· Registered
Joined
·
1,648 Posts
I reckon your talking about the shim, and its finish is just bare metal.

65 Hi-Po F/B (7 yr resto)
67 GTA F/B (small block) Mustang Owners Club of Austin (MOCA), TX
MCA 27479
http://albums.photopoint.com/j/View?u=1575609&a=11978710&p=43914197.jpg
 

· Registered
Joined
·
3,459 Posts
I just pulled my motor, a '68 302, and it was painted gray. I know nothing about the history of the motor so I'm not sure if it should be gray or not but it seemed like good paint so that makes me think it may be original.

Black primer 66 coupe, bench seat, 302, C-4, 3.55 TSD.
879 posts as "66 bench-coupe" on old VMF.
robert94928 on Yahoo Messenger
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top