Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part September's Ride of the Month Challenge!
1 - 5 of 5 Posts

·
Registered
Joined
·
1,793 Posts
Discussion Starter · #1 ·
I just purchased the Scott Drake export brace and a straight monte carlo bar for my 66 coupe and was wondering if after installation if it is possible to pull the engine w/o removing it? I realize the monte carlo bar would have to be taken off.

Thanks,

Dan
 

·
Registered
Joined
·
3,947 Posts
I just pulled my 351 based engine out of my 68 with the brace in place...The export brace is actually taller than the factory two piece braces on my 68..
 

·
Registered
Joined
·
4,670 Posts
Never had to remove them.
 
1 - 5 of 5 Posts
Top