engine vacuum
Join the discussion
Recommended Reading
-
Too hot to work on the Mustang, so I improvised.
Vintage Mustang ForumIt’s about 100 degrees here in sunny North Texas. Feels even hotter. We’ve got too much to do on my daughter’s car, so it’s time to get creative. I would have gotten a single larger unit, but my in-laws had these two 5,000btu units new in the box, so I’m giving them a test drive. After an hour...- 38
- 879
-
BlakeTX · updated
-
1965 A Code 289 4 speed clutch size
Vintage Mustang ForumHi all, can anyone recommend a good quality New Clutch assembly with release bearing and spigot shaft bearing 65 A code GT 4 spd assuming the engine is orig (which I don't know) Are they likely to be 10” or 10.4” from factory or is it a crap shoot, I had a clutch fork & release bearing failure...- 0
- 0
-
fastbackbhoy · updated
-
Another coilover question
Vintage Mustang ForumWell I just had to do it. My 69 Mach1 was a little too nose high so I decided to lower by cutting the coils. I went too far!! Cut two rounds out and the car lowered by close to 3 1/2 inches!! Too radical for my tastes so now I’m looking at springs. Ran across these coilover deals that bolt in...- 2
- 106
-
SkylaneAv8r · updated
-
Wix Oil Filiter-Factory filled Synthetic??
Vintage Mustang Forumjust ordered a case of these. what does this mean comes factory filled with synthetic oil, do they just wet the inside. i cant see them shipping a filter full of oil in a box of 12 how would they know what grade? https://www.rockauto.com/en/moreinfo.php?pk=360657- 0
- 0
-
Blues Power · updated
-
Leaf Springs; what we know about them, and what we don't
Vintage Mustang ForumAnother recent thread is prompting this. I was trying to do some fact-finding about who makes them, where they are made, and what they are made of. The information does not seem as readily available as I had hoped. I know Eaton Detroit is the big domestic U.S. manufacturer, and they proudly tout...- 101
- 8K
-
4ocious · updated
Join now to ask and comment!