Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
496 Posts
Discussion Starter #1
This car was sold to me as a factory GT K code and in my initial inspection it all checked out. Produced Aug. 65, DLX Int., and the wires for fog lights are factory wrapped in the wire harness from the firewall. But today I pulled the Fog switch and found a round hole! and the really odd thing is there is a burr on the outside of the hole! Now, if someone was faking a GT they sure would'nt even attempt to drill a hole from the inside of the dash, even if they could get up in there would they?
So what do I have here, a factory GT w/round hole, a dealer GT, or a phony w/ a PO that liked doing things the hard way?
By the way, the switch does not have a flat spot on it anyway although I've read it should to match the "D" shaped hole.

John
(must...find....build...sheet)
 
1 - 2 of 2 Posts
Top