Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
4,800 Posts
Discussion Starter #1
Since I still have leaking power steering, I am going to replace the flare seats on the pump and valve. I managed to get one seat out before our baseball game so I got that down, but any trick to getting the new ones in properly?

J. Boggs
 

·
Registered
Joined
·
3,486 Posts
I have replaced the by putting the new seat in position, then placing a brass punch on the seat (make sure it is larger that the flat surface of the seat) and tapping the punch lightly with a small hammer to hold it in place. You will properly seat it when you tighten on the hose.

68 GT500
68 1/2 CJ Coupe

MCA# 18519
 
1 - 2 of 2 Posts
Top