Vintage Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2,121 Posts
Discussion Starter #1 (Edited)
I'm replacing quarter and outer wheel well on 67 vert. I need to flatten it a couple inches just to be able to mate to inner. Any ideas on best way to do it.

thanks
 

·
Registered
Joined
·
2,211 Posts
That seems to the accepted method since the convertible wheel well is not available anymore.
If the car has nothing in the trunk and no undercoating you could cut the area out and weld in a flat piece of sheet metal.
 

·
Registered
Joined
·
7,107 Posts
As I recall, been 10 years. Dig out your hammer and anvil and have at it. Ingenuity, is your friend.
 
1 - 3 of 3 Posts
Top