Joined
·
1 Posts
I am working on a 69 Mach 1 with a 428 Cobrs Jet and need to know the proper finish for the flywheel cover. Thanks for your help.
Flywheel cover finish?
1 - 3 of 3 Posts
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Correct rally pac color - 1965
Concours ForumHey all! I have a 1965 with the deluxe interior. My interior is palomino. I found some info from an old post that says my car could have either the low or high profile rally pac. I am looking at the low profile so that I can more easily see my 5 gauge cluster. Which color rally pac would be...- 14
- 814
-
BODY BUCK TAG DECOD 69 MACH 1
Concours ForumOk, can anyone decode the letters “LP” stamped on the body buck tag for a 69 MACH1 428 SCJ. Got them all figured out but this one. Some people say louver panel, but I’ve never heard of them from the factory on a 69 MACH1. Any info would be appreciated. Thanks- 7
- 499
-
1967 Fastback Trunk Trim - Correct direction of Nuts on Trim Clips on the Ends?
Concours ForumSee pic below. Which is the correct orientation of these type of nuts? Open side out/away from the head of the clip, as pictured, or opposite of how it is installed in the pic?- 3
- 348
-
1965GTFB · updated
-
1970 Mach1 Carrier color
Concours ForumI am about to take apart my 9" rear end and replace the seals, change gear oil etc. Does anyone know what color the rear carrier should be (if any)? My car was built at the Metuchen Assembly plant. Alan- 7
- 204
-
Alan _MacDougall · updated
-
68 Console Gloss or Flat
Concours ForumI am restorig the console for my 68 . I sprayed the base and pad with Duplicolor gloss black and now wonder if it should have been flat? It looks like it was cleaned with armour all perhaps too shiny?- 2
- 163
Join now to ask and comment!