Vintage Mustang Forums banner

Foam Adhesive?

696 Views 6 Replies 4 Participants Last post by  autoxsteve
G
I'm in the process of rebuilding my heater so I ordered a kit to replace all the foam seals for the inside of the box. Has anyone done this, or know what kind of adhesive will work to glue the foam pieces in place? Thanks for the advice.

http://albums.photopoint.com/j/View?u=1606262&a=12247897&p=44606300.jpg
The G-Man's '65 K-code Fastback
Visit my website
1 - 1 of 7 Posts
All good advise, paint is the enemy of the glue. I used a spray on adhesive from Autozone. I wish I would have used the brush on headliner glue. If you can find some of that use it. Your car will get the new car smell back once the heater warms up the glue. BTW, don't forget the cowl seal I did and had to cut mine to get it on.

See my 69 convertible and the VMF parking lot at: http://www.geocities.com/Bishir1/FrontPage.html
http://www.jps.net/binay/webdocs/frontside_sig01.JPG
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top