Vintage Mustang Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
142 Posts
Discussion Starter · #1 ·
I have a set of rebuilt 289 heads. Early 1966 date which seems to be non-rail correct?
Question is what rocker arms can I fit. Ideally looking for a kit with arms and pushrods but I’m not sure if the later comp cam sets can be used with this set up?

Automotive tire Motor vehicle Locking hubs Rim Gas
 

·
Registered
Joined
·
142 Posts
Discussion Starter · #8 ·
Thanks all - I already have the cam shaft in place so I'm going to stick with that on this build.

I do not know what springs were used in the rebuild. My discussion with the shop that did the rebuild was keep it stock other than hardened valve seats.
 
1 - 7 of 7 Posts
Top