[Guest]

Today as I was going through the jungle of wiring in my engine compartment I got under the dash and decided to pull the gauges. I found my build sheet taped around a mass of wires. The thing practically disentegrated though. I'll let you know what I can make out after I take a closer look at it.

 

[DaveH]

That's a normal place to find one on Metuchen-built cars. The build sheet was folded until only the VIN showed, then taped tightly around the underdash wiring harness intended for that vehicle, presumably to prevent the installer from grabbing the wrong one.

 

[Smokin_Joe]

That's where I found mine too. Here's what it looks like - http://moostangjoe.tripod.com/Build_sheet.jpg
You can use this to compare with yours.

Vintage Burgundy 1966 Mustang GT Fastback (Midlife's younger brother)
MCA member #46447
http://albums.photopoint.com/j/View?u=1582316&a=12039610&p=45219205.jpg

 

[Guest]

yeah, mine was there too:

http://mike-o.home.att.net/MustangBuildSheet1.gif

mine was very fragile too, so before trying to unfold it, i put it in the microwave next to a shallow dish of water to soften it. it unfolded easily
good luck


[color:blue]'65 wimbledon white original coupe I6
'99 silver convertible V6

Check out Mike & Jackie's '65 Mustang </font color=blue>