Vintage Mustang Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
345 Posts
Discussion Starter · #1 ·
Does anyone have anything like this charthttp://www.boss302.com/framed.htm for a 67-68 mustang? I would like to check my engine compartment for a correct dimensions (ex. Monte Carlo bar).

Thanks,
Josh
 

·
Registered
Joined
·
2,881 Posts
You can look here for the measurements I used for my engine bay. These were taken from a 'never molested' '68 Vert by another VMF'r. Not sure if they're the same for a FB though. If you need frame specs, click on the BACK link at the bottom of my measurements page. Hope that's what you're looking for.
Gregg
 

·
Registered
Joined
·
345 Posts
Discussion Starter · #3 ·
Thanks for those docs. Mine measured perfect compared to the measurements.

Josh
 
1 - 3 of 3 Posts
Top