[Acooljt]

FREE 1967 200ci inline 6 motor. It ran and drove when I pulled it 18 years ago. The carb was rebuilt at that time as well. The engine probably needs an overhaul but it is a solid motor. If you want the C4 tranny with it, that will cost $100. Must pick up locally in North Pekin, IL.

 

[Acooljt]

 

[Travis98146]

If I were even close to IL, I'd pick up the whole kit in a heartbeat. Being in Seattle is a bit of a drive.

 

[swooshdave]

If I were even close to IL, I'd pick up the whole kit in a heartbeat. Being in Seattle is a bit of a drive.

Is Portland close enough?

 

[Acooljt]

If I were even close to IL, I'd pick up the whole kit in a heartbeat. Being in Seattle is a bit of a drive.

Yeah, I just donated it this weekend to a Mustang restoration shop, hopefully they can use it for parts or something. I didn’t want to junk it.

 

[Travis98146]

Is Portland close enough?

Portland is about 170 miles from where I live in Burien (just south of Seattle proper) so it would depend on what you have.

 

[swooshdave]

Portland is about 170 miles from where I live in Burien (just south of Seattle proper) so it would depend on what you have.

PM sent.

 

[hughnews1]

can I buy air cleaner and carb

 

[Acooljt]

I already donated the motor to a Mustang restoration shop since no one wanted it.

 

[swooshdave]

I already donated the motor to a Mustang restoration shop since no one wanted it.

I had pretty good luck on Facebook Marketplace. Several people contacted me and eventually a guy came over with his engine lift and helped me get it out of the car. He even handed me $100.

Yanking the six from a 1967

I'm planning on pulling the six out. I'd like to leave the C4 in for now but I suspect I have some things to change out on it so I might as well pull it too. I read up as much as I could but still had some questions. This is one of the more informative pages I read...

www.vintage-mustang.com