Vintage Mustang Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,912 Posts
Discussion Starter · #1 ·
This is a torque convertor that was used in a 1967 V8 Ford Mustang with a C4 automatic transmission. The converter worked great when it was installed a few years ago. It is a stock type torque convertor with 24 splines and it has a 10.25" bolt pattern. The shaft on the convertor has some discoloration but there are no grooves felt. It is in very good usable condition.

http://home.comcast.net/~dciab/ehay/tc1.jpg

If you want it all you have to do is pay for shipping from 94952 or better yet, come pick it up from my house in Petaluma. I frequent Davis as well, so you Sacramento folks are welcome to it too. Email me if you want it [email protected]
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top