Vintage Mustang Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2,154 Posts
Discussion Starter #1
The front clip I bought off eBay finally arrived at Dave's shop in IN. Now on to progress. I'll be sure to post updates and maybe a build progress.
Now to cut and mate the two!
 

·
Registered
Joined
·
35,893 Posts
How are you handling the VIN situation, if I may ask?
 

·
Registered
Joined
·
2,154 Posts
Discussion Starter #3
Dave plans on covering that question in the article that is being written in MM.
 

·
Registered
Joined
·
3,277 Posts
If the vin is in place on the original car can we weld a piece of tubing to the edge of it and attach the other end to say the rear quarter or floor pan thats not going to be disturb. Then we cut out everything else thats going to be replaced and we cut the area out where the vin goes from the donor car and place it so that the vin can be welded in place and ground down smooth. Now we can say that the original vin has never been removed and has stayed intact with the car.Thats my story and I'm sticking to it. What you say.
 
1 - 5 of 5 Posts
Top