Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part JUNE's Ride of the Month Challenge!
  • May's Ride of the Month contest ended with a tie! Go to this thread to vote on the winner! VOTE HERE
1 - 2 of 2 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter · #1 ·
Could some one please tell me if the sleeve for the end links are suppose to be the same length. the driver side is 1 1/2 with a 5" bolt. The passenger side is 2 1/4 with a 6 1/2 bolt. I bought a end link kit the sleeves did not come with it. The bolts are 6" long To short for the long sleeve. So if some one could tell me the right length of the sleeve, i can just make them. ( 67 fastback, 289, auto ) thank you
 

·
Registered
Joined
·
8,016 Posts
They should be exactly the same length. If they are any different your anti-sway bar will be different pressure on each side constantly.

Just cut your long sleeve to match the short one.

John Harvey
 
1 - 2 of 2 Posts
Top