Should the tabs that connect to the torque box/toe boards on the driver side be at the same angle? I know the floor dips a little bit for the steering column but the parts I have worry me a little. I have everything all clamped together but something is just not right. There is about 5-10 degrees difference in how the rear part of the driver side frame rails are lining up. Any pics or advice would help me out a lot. Thanks!
i replaced my lft front framerail. seems to be the inside tabs were not even close to the floorpan. just did what i had to do to make it work. looks good now after griding and painting. hope thats what you are asking. later
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
Vintage Mustang Forums
A forum community dedicated to vintage Ford Mustang owners and enthusiasts. Come join the discussion about restoration, modifications, NOS parts, troubleshooting, VIN codes, and more!