Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
7,294 Posts
Discussion Starter #1
I was looking at my car, which has all original aprons, and the seam betweeen the front & rear apron looks like it's in a different place on the driver's side than the passenger side. Something in my foggy memories says this is factory..am I crazy? My dad saw it and swears there's something wrong, but I'm either being hopeful, or that's factory. What's the deal?
Thanks
--Kyle
 

·
Registered
Joined
·
6,340 Posts
Im confused as to the seam your asking about . Are you talking about the seam on the flange the fenders bolt to ?

Edit :

I went and measured from the front edge of the core support to the line the aprons split at on the fender flange . My pass side is about 21 inches , the drivers side is about 21 1/8 inch . So , they are pretty close to 21 inches on each side to the overlapping sheet metal .
 
1 - 2 of 2 Posts
Top