Vintage Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
1966 coupe 289 with a newer 302
Joined
·
127 Posts
Discussion Starter #1
Hi there! I am planning to install the Edelbrock fuel filter below. My question is how I connected it to the fuel pump in a safe and very good looking way. Which exact part/ fuel line do I buy? I have a 66 coupe with a new 302 engine.

 

Attachments

·
Registered
Joined
·
37,647 Posts
I would buy the stock steel line for a 1965 289-2V. On the carburetor end it will be flared and have a 1/2-20 tube nut. You'll need an adapter from 1/2-20 inverted flare to the Edelbrock filter which I think might be -6AN but you should verify that first.
 

·
Registered
1966 coupe 289 with a newer 302
Joined
·
127 Posts
Discussion Starter #3
I would buy the stock steel line for a 1965 289-2V. On the carburetor end it will be flared and have a 1/2-20 tube nut. You'll need an adapter from 1/2-20 inverted flare to the Edelbrock filter which I think might be -6AN but you should verify that first.
thanks for this information, do you know how I can best verify this?
 

·
Registered
Joined
·
2,406 Posts
thanks for this information, do you know how I can best verify this?
I'd call CJ. Their customer service is great (in my experience).
 
1 - 4 of 4 Posts
Top