Gasket removal tips?
1 - 6 of 6 Posts
Joined
·
118 Posts
I like to use a lacquer thinner soaked rag to ease gasket removal followed by a razor blade type scraper.
Joined
·
853 Posts
Propane torch and a scraper.
Joined
·
4,375 Posts
+1
1 - 6 of 6 Posts
Join the discussion
Recommended Reading
-
C4 to T5 in a '65 Driveshaft Modification?
Mod and Custom ForumHave a 2002 T5 with its bell housing to swap in place of a C4. Is there a change needed in the drive shaft length from center of eye to center of eye from the original 65 drive shaft?- 13
- 401
-
New custom interior
Mod and Custom ForumSo much time has elapsed since I started having my 67 vert restored. After almost 2 yrs, the car is finally to a point where I can see some light at the end of the tunnel. The car started its journey at a resto shop and 2 weeks ago it was finally to the point it could be driven down the road to...- 17
- 417
-
67CustomStang · updated
-
-
MustangsPlus "Speed Shift" Remote Shifter
Mod and Custom ForumHere's an item that may be of interest to the Restomod folks. My '65 Fastback has the seat pans relocated lower & further aft to improve leg-room and head-room. When using a racing harness, it's a long reach to shift the transmission into 1st and 3rd. I am considering this remote shifter as a...- 4
- 192
-
jherrud · updated
-
Fuel injection thread, what did you choose and why ? Anybody on E85 ?
Mod and Custom ForumHey All, because alot of us are adding fuel injection, I'm asking what injection system do you have, and why did you choose that system ? What intake is the system on top of ? How is it working ? Did you have to write a new fuel graph ? Do you let the injection control the ignition timing ...- 27
- 720
Join now to ask and comment!