Joined
·
75 Posts
Thanks so much for the advice on Stuck Spindle Reprise. It totally worked and no there is no fuss or binding. Thanks again, You Rock!
Hail, Pooh-Bah Art
1 - 9 of 9 Posts
Joined
·
10,587 Posts
Art actually KNEW something??!?? He was able to help someone??!?? I need to sit down.......
hehehe....
hehehe....
1 - 9 of 9 Posts
Join the discussion
Recommended Reading
-
Differential question thread somewhere in cyberspace
Vintage Mustang ForumMy questions about the differential of my 66 has disappeared with the forum format changeover (or most likely I cannot navigate it properly to find it). So...I believe that someone replied back to me that if my rear end has two dimples (no rear end jokes hear!!) it is a 9" differential. What say...- 9
- 397
-
1966Stangman · updated
-
automatic shifter lamp
Vintage Mustang Forum67 coupe. automatic. no console. replacing my shifter because po had one that didnt belong to the car. i need to know where the indicator lamp plugs into. the schematics is chinese to me. the wire seems a bit too short to really plug into anything that close. it's a male/female connector. blue...- 4
- 99
-
scottl631 · updated
-
Burning up new turn signal switches
Vintage Mustang ForumBuilding a Shelby clone with a new ford base steering column from Ididit. There are now six 1157 tail light bulbs and when I apply the brakes the turn signal switch is overloading and melts till failure. Any help will be appreciated.- 3
- 0
-
Joed · updated
-
Parking Brake handle
Vintage Mustang ForumTrying to replace the broken parking brake handle. No luck getting the little "pin" out, at least with my small vise grips. But, the handle-shaft-cable is still installed so I want to remove and be able to work on this at the bench. Question, if detach the cable from equalizer bar will I be...- 9
- 149
-
Which brakes - consensus from the masses???
Vintage Mustang ForumLooking to get rid of PO front disc installation and replace with something better. Wilwood or Baer???? Or...??? What say ya'll???- 18
- 456
-
1966Stangman · updated
Join now to ask and comment!