Has anyone tried the Krylon Epoxy Primer?

2416 Views 7 Replies 3 Participants Last post by Guest, Apr 11, 2001

jpony645

Discussion Starter · Apr 10, 2001

I just found this at Lowe's and wondered if it would be good enough to use on my floorpans. 3 of them have some surface rust that I will hit with a wire brush on my grinder. I need something to go over them afterwards to protect and prevent anymore rust and I don't have access to a compressor and air gun.

Josh
Cullman,AL
64 1/2 Coupe
jpony645 on Yahoo IM
MKSU1DR on AOL IM
http://jpony645.tripod.com/images/left_frt_primer_small.jpg

Save

1 - 1 of 8 Posts

66emberglow

· #5 · Apr 11, 2001

Check out Zero Rust. That's what I used on my undercarriage.

http://www.zerorust.com

I reduced it a little and put it on with a brush. Good stuff.

I can't imagine epoxy primer in a rattle can being any good. The reason the epoxy works so well is that it uses an activator to get the juices flowing. Know what I mean?

/forums/images/icons/blush.gifClick here to see free live bare topless Coppertonecam images./forums/images/icons/blush.gif
/forums/images/icons/smile.gifMy new 64 1/2 vert/forums/images/icons/smile.gif

Save

1 - 1 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month