Vintage Mustang Forums banner

Has anyone tried the Krylon Epoxy Primer?

2417 Views 7 Replies 3 Participants Last post by  Guest
I just found this at Lowe's and wondered if it would be good enough to use on my floorpans. 3 of them have some surface rust that I will hit with a wire brush on my grinder. I need something to go over them afterwards to protect and prevent anymore rust and I don't have access to a compressor and air gun.

64 1/2 Coupe

jpony645 on Yahoo IM
1 - 1 of 8 Posts
Eastwoods, Corroless red primer would be better..
spray cans or brush on...good stuff for your application,
not cheap, i put it on my 50 f1 pickup frame abt 5 yrs ago, still holding up well...there are other brands also, color is similar to Fords original red primer , but they used laquer primer this is more of an enamel type primer for rust

[color:red]1965 A code fastback c4 with factory air ,power steering and front disc, 10/64 build ,a pre GT...GT</font color=red>
[color:green]My web site is [color:purple]here</font color=purple>
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.