I have had my block bored .030 over and now do i need a .030 over head gasket? Its for a 390 if that helps. I have a standard size set sitting here and was wondering if I could use it or if i have to buy a new set. thanx
IIRC, most head gaskets run about .150" over, so unless you bored it really big, you'll be fine...
Echo the comment on the front lettering going to the front, even if the gasket is upside down....caught myself about to make that mistake more than once over the years...*G*
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Vintage Mustang Forums
A forum community dedicated to vintage Ford Mustang owners and enthusiasts. Come join the discussion about restoration, modifications, NOS parts, troubleshooting, VIN codes, and more!