Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part September's Ride of the Month Challenge!
1 - 6 of 6 Posts

·
Registered
Joined
·
507 Posts
Discussion Starter · #1 ·
I think this may have been asked before, but I am prepping for headliner install. What would be the screws to put in before hand. I think it is coat hook (2), rear view mirror (3, rear upper trim piece across back of headliner (3?), and sun visor on each side (6). I am not going to be putting in the console, so I don't need those. Any other suggestions for the prep or are there other screws to put in before I put headliner in? Of course, I am putting them in so I can find them and cut a little X to get the screw after headliner is installed. Thanks.
 

·
Registered
Joined
·
182 Posts
You've pretty much got it right, except there are 6 screws, 3 sets of 2, for the trim piece that goes across the back.

http://www.reenmachine.com/albums/1967_mustang_fastback/0246.jpg
 

·
Registered
Joined
·
182 Posts
Also the attachment point for shoulder belts if you have them.
 

·
Registered
Joined
·
507 Posts
Discussion Starter · #6 ·
Thanks guys. Very helpful. I almost missed that there is 6 bolts for back piece.
 
1 - 6 of 6 Posts
Top