Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part JUNE's Ride of the Month Challenge!
  • May's Ride of the Month contest ended with a tie! Go to this thread to vote on the winner! VOTE HERE
1 - 1 of 1 Posts

5,552 Posts
Discussion Starter · #1 ·
I'm having comp cams take a look at these push rods and the 7/16" ped. screw in stud.

BTW, I found out that the tensile strength of grade 8 7/16 thread is 15,900 before kablamo - technical term. I don't know if it equates to this but that still was a heck of a lot of energy to do this.
1 - 1 of 1 Posts