Heater fan wiring?

1 - 1 of 1 Posts

Guest

Joined Jan 1, 1970

0 Posts

Discussion Starter • #1 • Mar 6, 2001

My fan will not work, I thought it was the fan so I pulled it and put juice to it and it works, So I checked the ground, it's good.. I there something else I should check? some sort of resistor or something.. I appreciate any advice...( I checked the fuses too)

1 - 1 of 1 Posts

Recommended Reading

Virtual Mustang Car Show

Vintage Mustang Forum

The engine bay thread got me thinking... it's nice to put a car to the screen names. On a car forum a pic of your engine bay is like a glimpse into your soul. But what about the rest of the car? Here's the rules. Three pictures: exterior, interior, engine bay. Any angle is fine. If you do some...
- 15
- 277
- jdub · updated a moment ago
302 buy build

Vintage Mustang Forum

hi, i just picked up a 95 302 roller block. It has been bored .30 over, has flat top pistons, Edelbrock Performer heads, E303 cam. The rotating assembly was balanced. It has roller tip rockers. i need to buy an intake, distributor, carb and everything else. this is going to get my butt moving...
- 6
- 130
- jtaoj · updated 2 h ago
Bleeding brakes. Frustrated, got to vent.

Vintage Mustang Forum

So I'm trying to bleed my brakes after replacing my master cylinder. I got a 65 6 cylinder with four wheel drums. I've gone around the car 5 times trying to get the brakes bled. I'm doing it with my wife doing the press, open, close, release method and got out all the big bubbles I could see...
- 30
- 1K
- O
  oldpaint · updated 2 h ago
Best interior HEAT insulation?

Vintage Mustang Forum

What is the best "heat" insulation for the interior? There are COUNTLESS threads on sound deadeners, but my understanding is that sound deadeners are different from heat insulation (or school me if I'm wrong). In my 1-hour commute each way every day, the interior gets pretty toasty and the...
- 20
- 9K
- Rorin67 · updated 2 h ago
Show me your engine bay!!

Vintage Mustang Forum

Since my car is in pieces and I’m going to rebuild the 289, I need to get some ideas on how to “dress” the engine bay. I don’t want to end up with an abomination of blue, red, yellow, black and chrome - so pop your hoods! I’ll get it started ;)
- 68
- 2K
- 67_ksb · updated 3 h ago

Top

Heater fan wiring?

Guest

Guest

Virtual Mustang Car Show

302 buy build

Bleeding brakes. Frustrated, got to vent.

Best interior HEAT insulation?

Show me your engine bay!!