Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
242 Posts
Discussion Starter #1
hi i need help with some pic of the front valanace how it was bolted onto the fender bolt go upward or downward and was all five bolt holes used on the bottom edge?or just three? it is for a nj built car had pic but i have messed placed them.. my body assembly manual has no pic of the front val or the front bumper mounting

Thanks Don
 

·
Registered
Joined
·
2,169 Posts
I think the instructions for the valance were in the Electrical Assembly manual.

I emailed you some pics. (wish I had an easy way to post them here). You install 5 clips on the valance along the top only (2 on each end and 1 in the middle) before you put it on. This leaves only one way for the bolts to go. from the top down.

Besides these 5 bolts at the top there is one bolt that goes up from the bottom center that goes to the latch support. After that you jsut have the short braces that go to the bumper brackets.

P.S. If you haven't done it already, you are going to want to install your front bumper before the valance.
 
1 - 2 of 2 Posts
Top