Vintage Mustang Forums banner

Hey 66CoupeNW

Jump to Latest Follow

1 - 2 of 2 Posts
T

·
Registered
Joined
·
4,800 Posts
Discussion Starter • #1 •
Hey Dan, If you are still in town, I forgot to tell you that Metro Mustang is only about 10 minutes from your hotel. They are great guys and have lot's of parts and stuff around.

J. Boggs


http://albums.photopoint.com/j/View?u=1574992&a=11972962&p=43108527.jpg
 
66CoupeNW

·
Registered
Joined
·
4,209 Posts
#2 •
Unfortunately I'm stuck in meetings all day with a bunch of boring Old Farts ... wait a minute ... I'm an Old Fart!

Hey, I'll bet they have a shiny new Magna 1" sway bar with your name on it!

DanM
66 Coupe, check her out at http://www.66CoupeNW.stangnet.com

"Imagination is more important than knowledge. It is a miracle that curiosity survives formal education" - Albert Einstein
 
1 - 2 of 2 Posts
Recommended Reading
Read More

  1. Early mustang data plates

    Vintage Mustang Forum
    Hi, I'm new to the forum, and here because I'm helping a widowed neighbor with valuing her husband's early Mustang. It's in black primer, and appears to be very straight - garaged for 20 years. The neighbor said the husband said that it's numbers matching 64 1/2, but I'd like to check on all...

  2. Tips for Rolling Fenders? / Rubbing would be an understatement!

    Vintage Mustang Forum
    Over the weekend I had a bit of unexpected fender rubbing when turning through a sharp dip and rise in a parking lot. Needless to say a few expletives were flying out of my mouth. Fender = screwed up and brand new tire = wasted. I am partly blaming this on the older Golden Legion, at least...

  3. Fuel lines

    Vintage Mustang Forum
    Recently I’ve rebuilt my 66 coupes fuel lines out of copper 5/16, but when I topped the tank up and excitedly turned the key I got nothing. So I pulled the line out of the filter to check if fuel was coming through which it isn’t, but I am getting pressure through the line. Is this a dodgy fuel...

  5. Bleeding brakes. Frustrated, got to vent.

    Vintage Mustang Forum
    So I'm trying to bleed my brakes after replacing my master cylinder. I got a 65 6 cylinder with four wheel drums. I've gone around the car 5 times trying to get the brakes bled. I'm doing it with my wife doing the press, open, close, release method and got out all the big bubbles I could see...

  6. Seat Foam For Back Seats

    Vintage Mustang Forum
    I am in the process of reupholstering the seats in my 66 convertible and I am considering tackling the job myself instead of paying someone to do the job. I have the foam inserts for the front bucket seats but it appears no one makes the rear seat foams. What have some of you done in the past...
Read More
About this Discussion
1 Reply
2 Participants
Last post:
66CoupeNW
Vintage Mustang Forums
A forum community dedicated to vintage Ford Mustang owners and enthusiasts. Come join the discussion about restoration, modifications, NOS parts, troubleshooting, VIN codes, and more!
Full Forum Listing
Explore Our Forums
Vintage Mustang Forum General Discussion (Non-Vintage Mustang) Mod and Custom Forum Classic Mustang Wanted Ads Concours Forum
Popular Communities
Community avatar for Home Entertainment
Home Entertainment
1,280,000+ members
Join
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Community avatar for Working From Home Forum - New!
Working From Home Forum - New!
25+ members
Join
Top