Vintage Mustang Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
704 Posts
Discussion Starter #1
Happy holidays everyone... one final question for 2019 ??

I recently completed a facelift restoration of my dash and heater box. Big horn pad and was in ok shape but I got the ring strip center part with the emblems.

How do you press this thing back in like the old one? It sits fine but it is jutting out just a tiny bit without clicking in.

I did use an iron to melt down the plastic tabs on back just the way the OE was done. ThisB secures the round pieces. But it won’t snap in like the old one on the chrome ring.

It has two screw mounts in back but there is nothing but foam ending on a metal plate to put screws through.... and the factory one was not attached to its screw mounts either.

pics for type reference ? Anyone do one of these before?
 

Attachments

1 - 1 of 1 Posts
Top