Vintage Mustang Forums banner

1 - 4 of 4 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter #1
I need to replace the horns in my 65 FB. Looking at the NPD catalogue they sell high pitch and low pitch horns. Since my car has 2 horns (if I remember correctly), do I buy 1 of each or 2 high or 2 low?
 

·
Registered
Joined
·
1,481 Posts
Just so you know those horns are not even close to original
looking. Different mounting brackets, and they are plastic. Might want to take a look on . I just picked up a working Low, repainted for $30.
 

·
Registered
Joined
·
680 Posts
your stock horns don't work??? Check to make sure they are getting power. Also, this sounds stupid, but, has worked for me before.Spray the insides with WD40. Let them set for a few minutes. Shark the excess WD40 out.Now see if they work. There is also a small screw with a locknut on the side of the horn. Loosen the locknut and,with someone holding down the horn button, turn the screw in one direction, then the other. They might start working.....Or not.....at least you tried...
 
1 - 4 of 4 Posts
Top