Vintage Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
564 Posts
Discussion Starter #1
I'm finishing a C3 to T-5 conversion on my 65 six cylinder. I had lots of things disconnected and am now going through everything to get it working again. Everything worked before I started, tail lights converted to Vintage LEDs, electronic flasher, it all worked before I started, I have the Falcon dash and don't have emergency flashers. My turn signals don't work at all (no flashing and no steady on) and I would like to test my turn indicator switch. Any help is appreciated.

Gregg
 

·
Registered
Joined
·
37,647 Posts
First place I'd look is for power at the turn signal flasher. Typically you'll have SOMETHING happening at the switch, even if it's broken... Usually no indicator lights and no rear lamps equals no power at the flasher. Do you have brake lights? If so, that means the wiring from the turn signal switch to the rear lamps is okay. If you hold your foot on the brake and move the turn signal lever the lamp on the side selected should go out when there's no power at the flasher.
 

·
Registered
Joined
·
564 Posts
Discussion Starter #3
Thanks Woodchuck, I didn't make much headway testing the switch - couldn't find enough points to test - so I went back to the flasher looking for power and found it. When I reconnected the flasher it started working so I'm all good.

Thanks
Gregg
 
1 - 3 of 3 Posts
Top