I hate salt. It gives High Blood pressure

1 - 1 of 1 Posts

Guest

Joined Jan 1, 1970

0 Posts

Discussion Starter • #1 • Mar 16, 2001

Drivers side rear wheel bay, and full rear quarter needs replaced, passenger side lower rear wheel bay and a quarter patch panel needed. looks like the rails may need replacing.
My poor daily driver.

I now need to find an affordable body shop. Sigh

1968 Coupe, 6cyl Std, Bench Seat. Driven through 10 years of College.

1 - 1 of 1 Posts

Recommended Reading

69 headers

Vintage Mustang Forum

I have a 1969 convertible with a 302, Edelbrock heads and C4 . I am wondering about a what kind of headers I should get that will fit well and plan on using Pypes 2.5" X pipe exhaust system. Any suggestions
- 8
- 99
- B
  BroWay · updated a moment ago
Parking Brake Delete 66

Vintage Mustang Forum

I did a 4r70w swap in my 66 coupe. One of the issues that I'm having is the parking brake is in the way/doesn't fit correctly/rubbing. Since I moved the trans mount to the rear for the 4r70w, the current configuration doesn't work. I've added a pipe nipple to the adjuster but it's just not...
- 12
- 79
- cturboaddict · updated a moment ago
Is this starter or carb heatsoak?

Vintage Mustang Forum

My 67 sat for a number of years and I decided to do a bit of work on it before getting it back on the road. I replaced the single plane intake and 500 CFM Carter carb with a dual plane Edelbrock RPM Air-Gap intake and Edelbrock 1406 600 CFM carb. Replaced the leaking radiator with an aluminum 2...
- 17
- 205
- K
  kurupt_03 · updated a moment ago
69 fastback lower rear qtr. repair pnls.

Vintage Mustang Forum

Hello All, Perhaps one of you have been down this road, Does anyone know who supplies the best quality lower rear quarter repair panels both inner and outer? Im looking for some that are of a heavy guage and a quality fit. Not like some of these imports I've seen, Anyone who has any experience...
- 0
- 2
- marshall · updated a moment ago
Subframe connector installation question

Vintage Mustang Forum

I’m going to get them welded on but have a bolt-on kit I’m installing right now. The rear is supposed to attach via a threaded hole on the rear subframe. Due to being 50 years old I assume, the holes don’t align between the connector and subframe. The subframe hole is shifted about 1/2” towards...
- 7
- 245
- O
  OldRookie72 · updated 20 m ago