These guys blow out realy easily, as the base that they sit on is ground, and the rivet heads on the back of the turn signal switch can easily short. I put black electrical tape on the back side of the switch as insulation.
I've decided its time to add the Pro Flo4 to my 66.. However heres the truth.. I'm no mechanic but I have a good one that I trust. He's happy to install it for me, as long as I try get everything together for him..cheaper for me.. So been reading here and need to ask for a bit of...
So I'm taking the 66 to the dyno on saturday. Old guy, neighbor of my uncle who's been tuning cars all his life. He wants me to bring my Holley 600 CFM carb and my Summit 500 cfm carb and see which one is better. Since I've never done anything like this before is there anything I should be on...
Just put a T5 in and swapped 3rd member to 3.55 LS.
After the T5 swap I had no vibration. After the gear swap I have a minor vibration at 70-80mph
I decided to check driveline angle. I used my iPhone as its all I have right now.
The first screen shot of a “pass” is with the car on...
1966 vert with Pony interior
Looking to mount a remote mirror on driver's side.
I had read on this forum that there was an outline of where the joystick should be mounted on the door panel, but there is none on my panel (aftermarket panel).
Any direction on where this is normally located?
The 1970 Ford Shop Manual section on tuning my Autolite 2100 carb seems incomprehensibly complex. Can anybody just give me the simple 1-2-3 fundamental adjustment procedure:
1) How do you adjust the idle air mixture screws optimally ?
2) At present, it seems as though the fast idle cam is...