Vintage Mustang Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,425 Posts
Discussion Starter · #1 ·
The rods are beveled where the bearings go on one side, does this bevel face towards the front of the motor or rear?
Thanks
 

·
Registered
Joined
·
1,076 Posts
The larger hole goes on the crank and the smaller one on the piston. Sorry I couldn't help it *G*

GRR456 said it best...

"Bevel goes towards the radius on the crankshaft journal. The un-beveled side faces the other rod and piston combo"
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top