Vintage Mustang Forums banner

Intake manifold water neck fitment

453 views 5 replies 5 participants last post by  bmcgc 
#1 ·
The threaded hole for the 90deg water neck is much larger on my aftermarket intake than the original. What is everyone else using in this case? Was planning on sizing it up locally but then I see the original extends down into the intake a bit and didn't know if that is necessary or not *see pic of original. If I can use a standard 90deg elbow from local store that would be ideal.
 

Attachments

See less See more
1
#5 ·
Thanks everyone!
 
#6 ·
Orielys has the proper size nipple. I try and stay away from extra hardware, its just more possible leak points.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top