is 8" rear 28 spline? no post
1 - 3 of 3 Posts
Joined
·
5,365 Posts
Far as I know & read the 31" spline wasn't used until '68 for big block cars like the 428 mtr. Older than that was 28 spline. My '67 GT 390 is 28 spline. Anyone else add to this?
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Recommendations for a New Driveshaft?
Vintage Mustang ForumAfter reading this .pdf from a 2014 post on this board I'm fairly sure that a standard 289 v8 coupe came with the rubber isolated drive shaft. Starting to lean towards putting re-balancing money (100-150$) towards a new driveshaft while pursuing other avenues of the vibrations. I've found that...- 36
- 1K
-
jsbenami · updated
-
Did I miss anything (C4 to T5 conversion)
Vintage Mustang ForumI just bought a T5/bellhousing/stock shifter and am now in the process of piecing together all of the miscellaneous parts that I need. I have read countless threads on this and other forums, and would like to try and make sure that I've thought of everything that I need to for my specific...- 2
- 2
-
PB65stang · updated
-
Crow's foot flare wrench for the win
Vintage Mustang ForumGetting the brake lines sorted on the 65 meant getting the rear most line on the bottom of the distribution block loose. The regular flare wrench was unable to assist as there's not enough room for the tool there. So I bought the crow's foot flare wrench set from Northern. Verified rotation...- 0
- 0
-
ylexot · updated
-
Rear Axle
Vintage Mustang ForumSo I installed these new Grab a Track Springs a few years ago. I have new wheels and tires. Is it me or is the rear tire sitting to close to the front of the wheel housing? It is the same on both sides. Any suggestions will be greatly appreciated. LJ- 8
- 225
-
Really struggling with brakes, drum rear, disc front
Vintage Mustang ForumTrying to get to first drive and I am now down to brakes. Right now car is on jack stands in the rear with an open diff, stock converter in the trans. When I put the car in gear at idle of course the passenger side wheel turns. I cannot get the wheels to stop with strong effort on the brake...- 33
- 717
-
Tallguy · updated
Join now to ask and comment!