Vintage Mustang Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,614 Posts
to check solenoid remove red with blue stripe wire "S" term and you should not be able to turn the motor over. then with wire stil off check voltage on wire - you should get 12 volts only in ign switch in start positon. if you see 12 volts in other positions that is your problem. also make sure your red wire with blue stripe does not go to "I" terminal on solenoid - this would put coil voltage on relay that pulls up starter relay in solenoid and might cause your condition
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top