Keep your women and children locked up
1 - 2 of 2 Posts
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Issue with upper control arm removal :/
Vintage Mustang ForumHi Guys, I seemed to have run into an issue regarding the coil spring and removing the upper control arm on my '68. Can I use a macpherson spring compressor to pull up the bottom coil?- 26
- 388
-
Cheap Aftermarket Carb for 66 289
Vintage Mustang ForumSo, I got a wonderful video sent to me from the body shop of my Mustang dumping fuel from the accelerator pump and power valve on the 2 barrel 289. To the point of the fuel ponding on the intake and splashing the exhaust when idling. Thankfully nothing caught fire. It's an older aftermarket 2100...- 10
- 155
-
cturboaddict · updated
-
1965 U joint pinion yoke cradle question
Vintage Mustang Forum:) Question is: My smaller pinion yoke does not have the "tabs" for the Ujoint holder or cradle that the big yoke has. Is this ok? Am I to understand that my 6 cyl 3 speed has the c-shaped locks on the inner ujoint and the ubolts to hold the outer whole ujoint in place after centering it...- 1
- 14
-
ILuv65FB · updated
-
Why does the shaft pull out of my headlight switch? 66 Mustang
Vintage Mustang ForumMy headlight circuit and fried, along with melting the headlight switch, so I replaced the wiring harness to the headlights, as well as the switch. I didn't replace the dash harness, as only one wire was fried -- which I replaced to the firewall. I had to insert the wires into the new headlight...- 1
- 4
-
Shaker hood kit measurements
Vintage Mustang ForumI purchased a 1969 Mustang Mach 1 at Barrett-Jackson last month. It has a 514 CID engine and I would love to put a shaker hood kit on it if I can make it fit. Does anyone have the measurement for a 428 CJ from the top of the carburetor ring to either the bottom of the hood or to the top of the...- 0
- 0
Join now to ask and comment!