Vintage Mustang Forums banner

1 - 3 of 3 Posts

1,579 Posts
Discussion Starter #1
There is a dimension of 4 7/8" from the lube fitting on the control valve to the inner tie rod stud if the control valve has been removed from the center link. There is an illustration of this in the factory service manual... Very important to get this dimension correct!
I saved this from an older post as I knew I would need it. Now it's time to put the newly rebuilt control valve and centerlink back together.

First of all is this applicable to 68 cars?
Does anyone have a pic of the manual page described?

1 - 3 of 3 Posts