Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,258 Posts
Discussion Starter #1
attempted to take my bumper off tonight, and only to find that my midget screw driver didnt have a large enough head, so i though I was try a somewhat larger flat-head and nope!

I didnt know I had to buy a large screw-driver *G*
 
G

·
Guest
Joined
·
0 Posts
good luck on getting the HUGE rusted phillips screws out. i'm on vacation this week, taking apart my '72 mach and spent 3 hours taking the front bumper off. since it is compostion material, i couldn't use the torch. i ended up using my dremel type air tool and cutting the bolts into 6 parts and chiseling them out. be very careful as the bumper is easily damaged. since mine is a driver, i'm going to replace them with low profile hex bolts.
bob
 
1 - 2 of 2 Posts
Top