Vintage Mustang Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,489 Posts
Discussion Starter #1
My new car has magnum 500s with the spinners instead of the typical black Mustang caps. I don't like the spinners so they need to go. Might be a dumb question but do these things just push on and therefore pull off or do I need to pull the wheels? They seem to be on there pretty tight.

The wheels are 14 X 7. Can you tell if the correct caps should be 2 inch or 2 1/8 inch just from the size of the wheel? Yeah, I can measure when I get the spinners off but wondered if anyone knew. Thanks, Drew
 

·
Registered
Joined
·
3,889 Posts
You need to remove the wheel and unbolt the spinner from the mounting plate .
 

·
Registered
Joined
·
430 Posts
yep. Two bolts per spinner. Believe they are 7/16. Why don't you like them? If you need some one to take them off your hands pm me :).
 

·
Registered
Joined
·
1,489 Posts
Discussion Starter #4
I like the traditional Mustang on black center caps better. The guy who put them on paid $120 for them. :shocked: They will be going up on eBay once I get them off and figure out what size they are. They look to be in great condition, I would certainly trade even up for a set of the better quality Mustang caps like NPD sells.
 
1 - 5 of 5 Posts
Top