Vintage Mustang Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
872 Posts
Discussion Starter #1
1) How large of roters can you fit on stock rims?
2) How large of rims would you need for 14" roters/
3) Has anyone here made there own moly tubing A Arms?
4) I've seen it done before(A Arms), how hard would it be?
5) Where can you find good mustang roll cages? 1967 fastback
6) How hard it is to rebuild a rack and pinion setup?

Thanks
 

·
Registered
Joined
·
6,630 Posts
can you tig weld? thats how hard moly A arms would be...
 

·
Registered
Joined
·
6,630 Posts
Well then.. yah you could probably make them quite easily. My advice would be to get ahold of some professional peices, or look at some on someones car (tcp?). I would advise using the screw in style ball joints the aftermarket uses. The hard part that i can see is getting that threaded pipe for that ball joint, and then the pivot point for frame side of the arm.

Good luck! if they turn out good make me a set /forums/images/icons/smile.gif
 
1 - 5 of 5 Posts
Top