All,
I have a 4 speed toploader for sale located in Maryland.
Ford Toploader 4 speed transmission
Body casting # : C5AR-7006-D
Tail casing # : C70R-7A040-A
Shaft size: 1 3/8 (shorter shaft)
Spline count: 28
$800.00 Cash sale only
Gears inside the case look good, and the data plate is missing from the side. I decided to go a different route with my build. Let me know if you have any questions.
This came out of my 68 fastback. It is not original factory equipment for my car and I don't know what it came out of. I do know it was said to be rebuilt by the previous owner 3 years ago and the car when I purchased it had 400 miles after it was restored. I took the transmission out about a...
Brand new from machine shop and balanced to 28 oz. Keith Black hyper pistons 4.030
https://www.summitracing.com/parts/uem-kb124-030
Some of the strongest oem rods, 1969 Ford C90E connecting rods. 010 under.
1969 Ford 351w crank cut. 010
All is balanced and numbered.
This will fit a 351w block...
This has very very little miles. Fresh Build. Project went in a completely different direction.
It was custom built. The ingredients: WILWOOD Forged Dynalite w/ Parking Brake, EATON Detroit Locker 31 Spline, RICHMOND 4.11 gear, STRANGE S/S 31 spline axles, Custom center section 1310 Moser Yoke...
Mike's Transmission 'ULTIMATE VASCO C4 TRANSMISSION' with JW ULTRA-BELL bell-housing.
I know, i know, never say never. .. pardon the hyperbole ... just sayin' it's pretty damn stout.
From their site - - Top of the line C4 transmission built for extreme conditions. Each with the parts &...
Edelbrock 1403 4bbl 500 CFM carburetor. Like new. Only used for about 500 miles. Ran very well. Selling because I’m switching to a Holley Sniper EFI.
$250 local pick up (near LAX airport)
$275 shipped
A forum community dedicated to vintage Ford Mustang owners and enthusiasts. Come join the discussion about restoration, modifications, NOS parts, troubleshooting, VIN codes, and more!
