Vintage Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Dealing with a good amount of rust and want to make sure it doesn't come back in frame rails and other areas etc. Looking for best results. May have to go with what's available in the area - Northern Virginia. Your comments/suggestions and recommendations are welcome. Thanks.
 

·
Registered
Joined
·
446 Posts
Blasting a car is not hard nor is it to expensive. You have to strip the car completely down. take everything off and take it to get blasted $500 to $1500 or go to a TSC store or one like it and buy you a blaster for 150.00 and material 200.00 and blast it yourself. Don't stay in one spot too long and use the approprate material. Clarke makes good beeds that wont hurt your metal. Read the label and choose your beeds. For the rusty areas, go with a rougher compound and for an area with no rust use a finer compound. DONT stay in an area to long.
 

·
Registered
Joined
·
915 Posts
Cover all your frame rail holes and seat holes. Blast all areas around it then do those areas by hand so that you dont get alot of media in there. Mike
 
1 - 3 of 3 Posts
Top