Vintage Mustang Forums banner
1 - 5 of 5 Posts
G

·
Discussion Starter · #1 ·
I got a lead on some cheap factory mags off a 94-95 mustang. I wanted to mount some slicks on them for my 67, but was not sure if the bolt pattern was exactly the same. Anyone know?

67 mustang coupe
70 mustang mach 1
88 mazda/ford mx-6

http://mhacf.com/chadn672b.jpg
http://mhacf.com/chadn672a.jpg
http://mhacf.com/mm1.jpg
 
G

·
Discussion Starter · #3 ·
I've got a set of 94 Waffle Stars, and they fit my '67 coupe with no problem. they are 205/55/16 They fit the back with no problem. I've got the Fenders off, so I can't tell. They seem like they'll fit.

http://members.tripod.com/tangdar/
'67 Coupe project car (Did I say project car? I meant pile of rust)
http://www.americainter.net/~fevans/tangdar_flintstone.jpg
 

·
Registered
Joined
·
220 Posts
They will fit the backs, but no the fronts. You can invest in some
spacers, but they get expensive fast. Make sure your run them on
all wheels. Improper or mixed back spacing can result in strange tracking problems. Something I would worry about on a drag car,
or an open track car.
 

·
Registered
Joined
·
220 Posts
They will fit the backs, but no the fronts. You can invest in some
spacers, but they get expensive fast. Make sure your run them on
all wheels. Improper or mixed back spacing can result in strange tracking problems. Something I would worry about on a drag car,
or an open track car.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top