Vintage Mustang Forums banner

Mustang II Steering

541 2
After taking the steering apart a few times in the last week, I've been kicking around the thought of putting in a Mustang II rack-n-pinion. This has been done before.

Anyone know of a good post (or thread) which discusses this?? Or a company which does the switch.


'66 Springtime Yellow Coupe
289, slightly warmed over
driven daily
1 - 3 of 3 Posts

Discussion Starter · #2 ·
total control products, they have a kit out for installing the mustang II. i don't know much about it, other than they put it in on hot rod t.v. the boys had it done in 20min. so how hard could it be?

· Registered
3,174 Posts
Rod and Custom Motorsports makes several Mustang II front suspension kits for our ol' 'Stangs.

Florence, SC

I have one of their earlier kits on a project fastback - it's pretty nice. The new ones, Ive noticed doesn't require cutting a section of the front frame rail out but I think you still have to torch off the lower control arm mount.

Dean T

Shikatta Ga Nai - "It cannot be helped"
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.