Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part JUNE's Ride of the Month Challenge!
  • May's Ride of the Month contest ended with a tie! Go to this thread to vote on the winner! VOTE HERE
1 - 6 of 6 Posts

·
Registered
Joined
·
688 Posts
Discussion Starter · #1 ·
i am restoring my rimblow steering wheel for my 70 mach 1 .i purchased a centre emblem for the center pad but i can not figure out how to get it in .is seems that i have to sterech the pad or something like that to insert it .whats up with that
 

·
Registered
Joined
·
409 Posts
Unless the 70 is different than the 73, and I think they are very similar if not identical, it is a pendant that fits an interior groove. So, Yeah, you may have to stretch the vinyl to pop it in.

Just be careful as it seems mine had a small tear on the side of the material
 

·
Registered
Joined
·
5,397 Posts
...you should thank God this isn't a porn site with a subject like that...
JK.
Not Really.
 

·
Registered
Joined
·
9,844 Posts
You need to heat the pad to make it more pliable. Hair dryer or soak it in very warm water. Spray on some silicone slip spray hen use a small dull screwdriver to pry it out.
 
1 - 6 of 6 Posts
Top