Vintage Mustang Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2,204 Posts
Discussion Starter #1
The bullet wheels my BF got for the FB are rubbing against the tierod and the spindle. Is there any way to fix this besides spacers? Would granada (or other) spindles give us any more room?
Any other creative solution ideas?
 

·
Incorporated Sell Out
Joined
·
17,130 Posts
IIRC the late model bullit wheels from the newer mustangs have the wrong BS for use on an early car and the only way to get them to work is with spacers.

Are these late model bullit wheels? or are they TTd's and you just calling them bullit wheels since they look like the wheels on the 68 FB from the movie of the same name?
 

·
Registered
Joined
·
2,204 Posts
Discussion Starter #4
They are off a late model Bullit. We figured we'd have to go with the spacer, but were hoping there was another way.
 

·
Registered
Joined
·
16,009 Posts
Whoa, you need a spacer that's about 15/16" ... BIG. So it requires the bolt on spacers. Check eHay or as a last resort goto www.karkraft.com and pony up for 'em. IMO it's wiser to get proper wheels and you come out safer for a little more change (when you factor in the cost of the adapters).
 
1 - 5 of 5 Posts
Top